ENGLISH - 4
CARING FOR YOUR LAWNMOWER
Cleaning (USE GLOVES) (N)
It is very important that you keep your lawnmower
clean. Grass clippings left in any of the air intakes or
under the hood could become a potential fire hazard.
1. Remove grass from under the hood with a piece of
wood or similar.
2. Using a soft brush - remove grass clippings from
all
air intakes.
3. Remove the blade, see Figure L, to gain access to
the fan and clean with a soft brush.
4. Wipe over the surface of your lawnmower with a
dry cloth.
• IMPORTANT: Never use water for cleaning your
lawnmower. Do not clean with chemicals, including
petrol, or solvents - some can destroy critical plastic parts.
At the End of the Mowing Season
1. Replace blade, bolts, nuts or screws, if necessary.
2. Clean your lawnmower thoroughly.
3. Ask your local Service Centre to clean the air filter
thoroughly and carry out any service or repairs
required.
4. Make sure that the electric cable is coiled properly.
Carrying your Lawnmower Ensure the blade is facing
away from you.
Storing your Lawnmower
Store in a dry place where your lawnmower is protected
from damage.
FAULT FINDING HINTS
Fails to Operate
1. Is the Power Turned On?
2. Check the fuse in the plug, if blown replace.
3. Fuse continues to blow?
Immediately disconnect from the mains
electricity supply and consult your local
approved Service Centre.
Poor Flotation
1. Disconnect from the mains electricity supply.
2. Clean the underside of the hood and the fan
blades.
3. Raise to a higher height of cut. See Adjusting the
Height of Cut.
4. If poor flotation persists?
Disconnect from the mains electricity supply
and consult your local approved Service
Centre.
Excessive Vibration
1. Disconnect from the mains electricity supply.
2. Check that the blade is fitted correctly?
3. If the blade is damaged or worn, replace it with a
new one.
4. If vibration persists?
Immediately disconnect from the mains
electricity supply and consult your local
approved Service Centre.
GUARANTEE AND GUARANTEE POLICY
If any part is found to be defective due to faulty
manufacture within the guarantee period, Electrolux
Outdoor Products, through its Authorised Service
Repairers will effect the repair or replacement to the
customer free of charge providing:
(a) The fault is reported directly to the Authorised
Repairer.
(b) Proof of purchase is provided.
(c) The fault is not caused by misuse, neglect or faulty
adjustment by the user.
(d) The failure has not occurred through fair wear and
tear.
(e) The machine has not been serviced or repaired,
taken apart or tampered with by any person not
authorised by Electrolux Outdoor Products.
(f) The machine has not been used for hire.
(g) The machine is owned by the original purchaser.
(h) The machine has not been used outside of the
country for which it was specified.
(i) The machine has not been used commercially.
* This guarantee is additional to, and in no way
diminishes the customers statutory rights.
Failures due to the following are not covered, therefore
it is important that you read the instructions contained in
this Operator's Manual and understand how to operate
and maintain your machine:
Failures not covered by guarantee
* Replacing worn or damaged blades
* Failures as a result of not reporting an initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the product in
accordance with the instructions and
recommendations contained in this Operator's Manual.
* Machines used for hire are not covered by this
guarantee.
* The following items listed are considered as wearing
parts and their life is dependent on regular
maintenance and are, therefore not normally subject
to a valid warranty claim: Blades, Electric Mains cable.
* Caution! Electrolux Outdoor Products does not
accept liability under the warranty for defects
caused in whole or part, directly or indirectly by the
fitting of replacement parts or additional parts that
are not either manufactured or approved by
Electrolux Outdoor Products, or by the machine
having been modified in any way.
ENVIRONMENTAL INFORMATION
Electrolux Outdoor Products are manufactured under an
Environmental Management System (ISO 14001)
using, where practical, components manufactured in the
most environmentally responsible manner, according to
company procedures, and with the potential for
recycling at the end of the products’ life.
• Packaging is recyclable and plastic components
have been labelled (where practical) for
categorised recycling.
• Awareness of the environment must be considered
when disposing of ‘end-of-life’ product.
• If necessary, contact your local authority for
disposal information.