Filter
Top Products
M N
R
Starting and Stopping
To Start your Lawnmower
1. Form loop in mains cable and push the loop through
the slot. (M)
2. To secure, position loop over the hook and pull the
cable back through the slot (N).
3. Connect plug to mains and switch on.
4. Tilt the handle downwards to slightly raise the front of
the lawnmower and to reduce the risk of lawn damage
whilst starting.
The switchbox is provided with a lock-off button (P1)
to prevent accidental starting.
5. Press and hold the lock-off button (P) on the switch-
box, then squeeze one of the Start/Stop levers to-
wards the upper handle (Q).
6. Continue to squeeze the start/stop lever towards the
upper handle and release the lock-off button (R).
7. Lower the lawnmower to its proper operating position
and commence mowing.
• NOTE - There are two start/stop levers fitted. Ei-
ther one can be used for starting the lawnmower.
• IMPORTANT - Do not use the start/stop levers in-
termittently
To Stop your Lawnmower
1. Release the pressure on the Start/Stop lever.
P Q
1
How to Mow
1. Start mowing the edge of the lawn nearest to the power point so the cable is laid out on the lawn you have already
cut. (S)
2. Mow twice a week during the growing season, your lawn will suffer if more than a third of its length is cut at one time and
this may also result in poor collection.
Do Not Overload Your Mower
Mowing long thick grass may cause the motor speed to drop, you will hear a change in the motor sound. If the motor speed
drops you may overload your lawnmower which may cause damage. When mowing in long thick grass a first cut with the
cutting height set higher will help reduce the load. See Cutting Height Adjustment.
Safety Cut-Out
The Motor is protected by a Safety Cut-Out which is activated when the blade becomes jammed or if the motor is overloaded.
When this occurs, stop and remove the plug from the power supply. The Safety Cut-Out will only reset when the start/stop lever is
released. Clear any obstruction and wait for a few minutes for the Safety Cut-Out to reset before continuing to use the mower.