Filter
Top Products
Fitting Upper Handles to Lower Handles (D & E)
1. Ensure the upper handle is located correctly with the
lock-off button on the switchbox uppermost
2. Ensure the upper handle and the lower handle are
aligned correctly.
3. Insert the nut into the handle knob. (if applicable)
(D1)
4. Fit the bolts, washers and handle knobs.
5. Fit the cable to the handles with the clips provided.
Make sure the cable is not trapped between the han-
dles.
Upper Handle Assembly
D
E
Venturer 370 RE420/420c
Grassbox Assembly
F G
Venturer 370
Grassbox Assembly - Venturer 370.
1. Insert the grassbox handle into the top of one of the
grassbox halves. Press firmly down and forward
until the handle clicks into position (F)
2. Turn the grassbox half over and insert screw into
hole (as illustrated in fig F) and tighten fully.
3. Locate grassbox upper into grassbox lower (G).
Align clips, ensure all clips are correctly located.
4. Clip the two halves together.
5. Ensure all clips are securely connected.
Grassbox Assembly - RE420/RE420c
1. Insert the grassbox handle into the top of one of the
grassbox halves. Press firmly down and forward
until the handle clicks into position (F)
2. Turn the grassbox half over and insert screw into
hole (as illustrated in fig F) and tighten fully.
3. Position the two grassbox halves together and press
each location point (H) into position without
fully
connecting the clips. When the location points are
matched correctly firmly press the grassbox together
until all clips are securely connected.(J)
Fitting the Grassbox
1. To attach the grassbox to your lawnmower, lift the
safety flap (K) and make sure the discharge chute is
clean and free from debris.
2. Locate fully assembled grassbox onto 2 location
points at the rear of the deck. (K)
3. Locate safety flap onto the top of the grassbox.
Ensure the grassbox is securely located.
• Removal is the reverse procedure.
• Please Note:- Ensure no gap remains between
the safety flap and the grassbox.
• Where grass collection is not required you can
use the lawnmower without the grassbox.
Ensure the safety flap is fully closed.
J
K
H
RE420
RE420c
RE420
RE420c
location
point
clips
1