Filter
Top Products
4
Cutting Height Adjustment
• Height of cut is adjusted by raising or lower-
ing the wheels.
• NOTE
All 4 wheels must be adjusted to the same
position:
HEIGHT OF CUT
WHEELS
Low Hole 1
Medium Hole 2
High Hole 3
• NOTE
A medium height of cut is recommended for
most lawns.
1. To remove the wheel assembly turn the wheel
hub in an anti-clockwise direction.(E)
2. Select one of the 3 holes in the mounting plate
and note it as the other 3 wheels will need to be
adjusted to the same position.(F)
3. Locate fixing bolt through hole in hub cap, wheel
and selected hole in mounting plate.(F)
4. Turn the wheel hub in a clockwise direction until
the wheel assembly is securely located to the
deck.(E)
5. Using the same height adjustment position
repeat the procedure for the other 3 wheels.
1
2
3
F
mounting
plate
holes
wheel
hub cap
fixing bolt
to remove
turn anti-clockwise
to fit
turn clockwise
E
Grassbox
Fitting Fully Assembled Grassbox to
Lawnmower. See Fig G.
1. Lift safety flap.
2. Make sure the discharge chute is clean and free
from debris.
3. Locate fully assembled grassbox onto 2 location
points at the rear of the deck
4. Locate safety flap onto the top of the grassbox.
Ensure the grassbox is securely located.
• IMPORTANT !
AFTER FITTING ENSURE NO GAP REMAINS
BETWEEN THE SAFETY FLAP AND THE
GRASSBOX.
• Removal is the reverse procedure.
• For larger areas of grass where grass collection
is not required you can use your lawnmower
without the grassbox. Ensure the Safety Flap is
fully closed. The design of the safety flap per-
mits the cut grass to be discharged downward
behind the machine.
G