Filter
Top Products
Maintenance
S
R
• WARNING
Disconnect from the mains electricity supply, be-
fore attempting any maintenance or adjustment.
Cutting head continues to rotate after the trimmer
has been switched off. Keep fingers and hands
clear of the line cutter on leading edge of guard.
Caring for your Power Trim
After you have finished using your Flymo Power Trim fol-
low the procedure below:
AVOID ACCIDENTAL STARTING. REMOVE PLUG
FROM MAINS AND KEEP FEET AWAY FROM THE
SWITCH LEVER WHEN: CLEANING AROUND THE IN-
SIDE OF THE SAFETY GUARD, REMOVING OR RE-
FITTING SPOOL CAP, MANUALLY FEEDING OR
REPLACING NYLON LINE.
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning fluids,
or solvents, just remove debris with a suitable tool, a
soft brush or dry cloth.
3. Using a soft brush, clean around the inside of the
safety guard, the cutting head (Fig R) and the motor
housing air vents. (Fig S)
4. Inspect the trimmer carefully, especially the parts of
the cutting head.
5. If your trimmer is damaged in any way contact your
local approved service centre.
• Never use a damaged trimmer.
6. Store in a cool, dry place and out of reach of children.
Cable Storage
1. Your mains cable can be stored on the product as il-
lustrated in Fig T.
2. Wind cable carefully to avoid kinking.
3. To release the cable press the button and the hook
will drop down (Fig V).
4. Push cable hook fully back into position.
VT