Filter
Top Products
To start your Hedgetrimmer
EasiCut 420/450/510
1. There are three switch levers fitted to your Hedgetrimmer.
2. Main switch lever (E1) and one other switch lever
need to be held in the operating position (E2 or
F1) for the product to start.
To start your Hedgetrimmer
EasiCut 600XT
1. There are four switch levers fitted to your Hedgetrimmer.
2. To start, push forward the lock-off button (G1), squeeze
the main switch lever (G2), release lock-off button.
3. Main switch lever (G2) and one other need to be
held in the operating position (G3, H1 or J1) for
the product to start.
To stop your Hedgetrimmer
• Move Hedgetrimmer away from cutting area
before stopping.
1. To stop, release any switch lever.(K, L)
Starting and Stopping
B1 B2
D
E
K
G H
J
F
L
1
1
2
Before Use
B3
C1 C2
Before starting your Hedgetrimmer.
• Securing the cable in the Belt Clip helps keep
the cable away from blade.
1. Push up the hook on the Belt Clip (B1)
2. Place the rear section of the Belt Clip behind
your belt (B2)
3. Push down the hook on the Belt Clip to secure it
onto your belt (B3)
4. Form a loop in the mains cable and push the loop
through the hole in the Belt Clip (C1) ensuring the
coil in the cable is close to the clip.
5. To secure, position the loop over the hook and
pull back (C2).
6. Connect to mains and switch on
7. Remove blade cover (D).
2
1
3
1
1