Filter
Top Products
Cutting Height Adjustment
Wheels - Front Cutting Height Adjustment
• Height of cut is adjusted by raising or lower-
ing the front wheels and rear roller.
• NOTE
The wheels and the roller must be adjusted
to the same position:
HEIGHT OF
CUT WHEEL ROLLER
Low Hole 1 Position H
Medium Hole 2 Position J
High Hole 3 Position K
• NOTE
A medium height of cut is recommended for
most lawns.
1. To remove the wheel assembly turn the wheel
hub in an anti-clockwise direction.(E)
2. Select one of the 3 holes in the mounting plate
and note it as the other wheel will need to be
adjusted to the same position.(F)
3. Locate fixing bolt through hole in hub cap, wheel
and selected hole in mounting plate.(F)
4. Turn the wheel hub in a clockwise direction until
the wheel assembly is securely located to the
deck.(E)
5. Using the same height adjustment position
repeat the procedure for the other wheel.
Roller and Rear Height Adjustment
H - LOW
J - MEDIUM
K - HIGH
1. Select one of the 3 locations and note it as the
other lever will need to be adjusted to the same
position. (H, J or K)
2. Lift the lever out of location and rotate the roller
to the desired position. (G)
3. Using the same height adjustment position
repeat the procedure for the other lever.
to remove
turn anti-clockwise
to fit
turn clockwise
E
1
2
3
F
mounting
plate
holes
wheel
hub cap
fixing bolt
G H
J K
Grassbox
Fitting Fully Assembled Grassbox to Lawnmower.
See Fig L.
1. Lift safety flap.
2. Make sure the discharge chute is clean and free
from debris.
3. Locate fully assembled grassbox onto 2 location
points at the rear of the deck
4. Locate safety flap onto the top of the grassbox.
Ensure the grassbox is securely located.
• IMPORTANT !
AFTER FITTING ENSURE NO GAP REMAINS
BETWEEN THE SAFETY FLAP AND THE
GRASSBOX.
• Removal is the reverse procedure.
• For larger areas of grass where grass collection is
not required you can use your lawnmower without
the grassbox. Ensure the Safety Flap is fully
closed. The design of the safety flap permits the
cut grass to be discharged downward behind the
machine.
L