Filter
Top Products
Check for damaged or worn parts
Please contact your local Husqvarna Outdoor
Products Approved Service Centre for further
information or for replacement of damaged or worn
parts.
• ON/OFF Switch - Ensure switch functions
properly by moving the switch to the OFF
position. Make sure motor stops; then restart
motor and continue.
• Inlet Cover - Discontinue use of unit if inlet cover
fails to latch properly or if it is damaged in any
way.
After each use
Inspect and clean unit and labels
Stop unit and disconnect the mains electricity
supply.
• After each use, inspect complete unit for loose or
damaged parts. Clean the unit using a damp
cloth with a mild detergent.
• Wipe off unit with a clean dry cloth.
Clean collection bag
IMPORTANT: THE COLLECTION BAG
MUST BE PROPERLY EMPTIED.
• You must properly empty and maintain the
collection bag to avoid deterioration and
obstruction of air flow.
• Remove the collection bag from the unit and
empty after each use. Do not store bag without
emptying the bag of all contents (grass, leaves,
etc.).
• Wash the bag once a year. Remove the bag from
the blower and turn the bag inside out. Wash the
bag with a water hose. Allow the bag to hang and
dry completely before you reuse the bag.
WARNING: Perform the following steps after
each use:
• Stop the unit and disconnect the mains electricity
supply.
• Allow motor to cool before storing or
transporting.
• Store unit with all guards in place. Position unit
so that any sharp object cannot accidentally
cause injury.
• Store unit unplugged, well out of the reach of
children.
Seasonal storage
Prepare unit for storage at the end of the season or
if it will not be used for 30 days or more. If your
blower is to be stored for a period of time:
• Stop the unit and disconnect the mains electricity
supply.
• Clean the entire unit before lengthy storage.
• Open inlet cover and clean any dirt, grass, or
debris that has collected. Inspect the blower and
all tubes. Close and make sure the cover is
latched.
• Clean air vents and air inlet of debris.
• Store your unit in a well ventilated area and
covered, if possible, to prevent dust and dirt
accumulation. Do not cover with plastic. Plastic
cannot breathe and may cause condensation and
eventual rust or corrosion.
• Check entire unit for loose screws. Replace any
damaged, worn, or broken parts.
Storage
Service
WARNING: All internal or electrical service
MUST be performed by your local Husqvarna
Outdoor Products Approved Service Centre.
How to remove an object from the air
intake
WARNING: Stop the unit and disconnect the
mains electricity supply before opening the inlet
cover. The motor must be stopped and the impeller
blades no longer turning to avoid serious injury from
the rotating blades.
1. While holding the inlet cover open, remove the
vacuum tubes. The inlet cover must be held open
through all remaining steps.
2. Carefully reach into the vacuum opening and
clear out the air intake area. Clear all debris from
impeller.
3. Inspect the impeller for cracks. If cracked or
damaged, do not use the unit. Have parts
replaced by your local Husqvarna Outdoor
Products Approved Service Centre. Do not
attempt to replace them yourself.