Filter
Top Products
page 4
1. Assemble Funnel
Place funnel halves on flat surface with narrow opening
facing up. Align both halves and press locating pin
nearest narrow opening of funnel half into locating hole
on adjacent funnel half. See figure 3. Using two (2) #8 x
1/2” screws, fasten both halves together. See Figure 4.
N OT E : Flange on funnel half overlaps outer surface of
adjacent funnel half as shown in figure 3.
Rotate Funnel 180º and press locating pin nearest
large opening of funnel half into locating hole on adja-
cent funnel half. See figure 3. Using two (2) #8 x 1/2”
screws, fasten both halves together. See Figure 4
2. Attach Funnel to Housing
Place narrow opening of funnel on upper end of hous-
ing and position funnel so that flat areas of funnel are
located at the right and left housing towers. Align boss
on funnel with hole at top center of housing tower as
shown in figure 5. Repeat for opposite side. With boss-
es aligned, press funnel firmly down onto housing.
Apply pressure all around edge of funnel until funnel is
seated evenly around the housing. Fasten funnel to
right side of housing by inserting a #10 x 3/4" long pan
head phillips screw into large screw hole opening at
top front edge of housing tower, and tighten using a
phillips screwdriver. CAUTION: Do not over tighten
screw. See figure 5. Repeat for left side.
NOTE: While inserting screw into screw hole opening,
keep funnel tab in place by pressing down on inside
surface of funnel opposite tab so that screw passes
through hole in funnel tab.
ASSEMBLY
PREPARATION
Your Owner’s Manual has been developed to help you
assemble the unit and to understand its safe operation. It
is important that you read your manual completely to
become familiar with the unit before you begin assembly.
1. Tools you will need
#2 phillips head screwdriver
FIGURE 3
Narrow End
of Funnel
Locating Pin
Hole
FLANGE
Locating Pin
FIGURE 4
Wide
Opening
Narrow Opening
#8 x 1/2” screw
(two places)
FIGURE 5
Push
Housing
Tower
Funnel Tab
Funnel
Funnel
Boss
Screw
#10 x 3/4" Long