Filter
Top Products
• Fill the sandbox with up to 500 lbs. of sand.
Let’s Play
Parts
Base
Cover
Cap
8 Panels
• Place the base on the surface in which you intend to use
the sandbox.
Note:
Assemble the panels to the base going in a clock-
wise direction.
• Fit the grooves on one of the panels to the ribs on the
base, as shown.
• Fit another panel onto the base. Snap both tabs on the
first panel into the slots on the second panel.
• Insert and snap the cap to the base and panels.
Assembly is now complete.
1
3
Tab
Tabs
Slots
Grooves
2nd Panel
Clockwise
1st Panel
Base
Ribs
Cap
Base
Assembly Assembly
Helpful Hint: You may have difficulty snapping the panel
tab closest to the base. Lift the assembly up slightly.
While pushing up from the underside of the assembly
(directly below the tab), push down on the topside of the
assembly (directly above the tab).
• Insert and snap the tab on the outside edge of the first
panel into the slot in the outside edge of the second
panel.
• Repeat this procedure to assemble the remaining six
panels to the base.
Tabs
Push Down
Push Up
2