Filter
Top Products
17
Regular Maintenance
BATTERY MAINTENANCE
Checking the Battery Fluid
1. Raise the seat plate to access battery.
2. Remove the rubber strap and battery box cover.
3. Remove the battery filler cap (A, Figure 14). Fluid
must be even with the split ring full mark. If not, add
distilled water.
4. Reinstall the filler cap.
5. Reinstall the the battery box cover and rubber strap.
Cleaning the Battery and Cables
1. Disconnect the cables from the battery, negative
cable first (C, Figure 14).
2. Remove the battery and clean the compartment with
a solution of baking soda and water.
3. Clean the battery terminals and cable ends with a
wire brush until shiny.
4. Reinstall the battery and reattach the battery cables,
positive cable first (see B, Figure 14)
5. Coat the cable ends and battery terminals with petro-
leum jelly or non-conducting grease.
A
C
B
Figure 14. Battery Compartment
A. Vent Cap(s)
B. Positive (+) Cable & Terminal
C. Negative (-) Cable & Terminal
WARNING
Be careful when handling the battery. Avoid
spilling electrolyte. Keep flames and sparks away
from the battery.
When removing or installing battery cables,
disconnect the negative cable FIRST and reconnect
it LAST. If not done in this order, the positive
terminal can be shorted to the frame by a tool.