Ferris Industries 5000/72 Lawn Mower User Manual


 
29
05
LOOSEN
A
C
B
TIGHTEN
Figure 31. Removing the Blade
Figure 32. Balancing The Blade
Figure 33. Installing The Blade
A. 4x4 Wood Block C. Blade Bolt
B. Flat Washer
Nail
SERVICING THE MOWER BLADES
1. Blades should be sharp and free of nicks and dents.
If not, sharpen blades as described in following
steps.
2. To remove blade for sharpening, use a wood block to
hold blade while using two 15/16” wrenches to
removing the blade mounting bolt and nut (Figure
31).
3. Use a file to sharpen blade to fine edge. Remove all
nicks and dents in blade edge. If blade is severely
damaged, it should be replaced.
4. Balance the blade as shown in Figure 32. Center the
blade’s hole on a nail lubricated with a drop of oil. A
balanced blade will remain level.
5. Reinstall each blade with the tabs pointing up toward
deck as shown in Figure 33. The five (5) blade spac-
ers, blade, washer and bolt must be reinstalled in the
exact same order in which they were removed.
Secure with a bolt and hex nut. Use a wooden block
to prevent blade rotation and torque bolts to 70 ft.lbs.
(94 N.m.).
WARNING
Mower blades are sharp. For your personal
safety, do not handle mower blades with bare
hands. Careless or improper handling of blades
may result in serious injury.For your personal
safety, blade mounting bolts must each be
installed with a flat washer then securely
tightened. Torque blade mounting bolts to
70 ft.lbs. (94 N.m.)
Regular Maintenance