Ferris Industries IS5000Z/D34 Lawn Mower User Manual


 
34
01
Troubleshooting, Adjustment & Service
PARKING BRAKE ADJUSTMENT
1. Disengage the PTO, stop the engine, block the front
wheels, remove the ignition key, and engage the
parking brake.
2. Locate the upper brake spring (A, Figure 39).
3. With the parking brake engaged, measure the com-
pressed spring length. The spring should be
2” to 2-1/8” (5,0-5,4cm) when compressed.
4. If the spring is not within this range, jack up the rear
of the machine and secure with jackstands. Remove
both drive tires.
5. Locate the lower brake spring (A, Figure 40), adjust-
ment nuts (B, Figure 40) and adjustment link (C,
Figure 40).
6. Release the parking brake and turn the adjustment
nuts to compress or release the upper spring. Lock
the nuts against the adjustment link (C, Figure 40).
If this does not correct the braking problem, see
your dealer.
2" - 2-1/8"
(5,0 - 5,4cm)
FRONT
Figure 39. Parking Brake Adjustment
A. Upper Brake Spring
A
Figure 40. Parking Brake Adjustment
A. Lower Brake Spring
B. Adjustment Nuts
C. Adjustment Link
A
C
B
CAUTION
Do not adjust the spring to be shorter than
2” (5,0cm) when compressed. This may damage
the brake caliper.