Filter
Top Products
20
Troubleshooting, Adjustment & Service
1/4"
(0,6cm)
ADJUST HERE
BRAKE ADJUSTMENT
When the levers are fully engaged (squeezed), there
should be 1/4” (0,6cm) of clearance in between the han-
dle bars and brake handles (see Figure 11).
To adjust:
1. Turn the wing nut (figure 11) to adjust the distance
between the handle bars and steering levers.
2. Fully engage (squeeze) the brake lever and remea-
sure the distance. Repeat adjustment until desired
measurement is achieved.
3. Repeat adjustment procedure for other side of
machine.
Mount Blade Caster
Height Of Cut Position Spacers Spacers
2” U 1 3
2-1/4” U 2 3
2-1/2” U 1 2
2-3/4” U 2 2
3” U 3 2
3-1/4” L 2 1
3-1/2” L 1 0
3-3/4” L 4 1
4” L 3 0
4-1/4” L 4 0
4-1/2” L 5 0
MOWING HEIGHT ADJUSTMENT
The mowing height is determined by three factors: the
mount position of the mower deck, the number of blade
spacers above the spindle and the number of caster
spacers above the caster arm.
Refer to the chart to the right for the correct settings to
obtain the desired height of cut. Remember, the “Blade
Spacers” and “Caster Spacers” columns refer to the
number ABOVE the spindle and caster arm.
Figure 11. Brake Adjustment