Ferris Industries 5901178 Lawn Mower User Manual


 
45
Troubleshooting
DECK LEVELING ADJUSTMENT
NOTE: Before adjusting the deck level, the deck lift
rod timing must be checked and/or adjusted.
1. Park machine on a flat, level surface. Disengage
the PTO, stop the engine and engage the parking
brake. Rear tires must be inflated to 18 psi (1,24
bar); front tires to 25 psi (1,72 bar).
2. Install the cutting height adjustment pin in the
4” (10,2 cm) position. See Figure 42.
3. Place 2 x 4 blocks under each corner of the
mower deck with the 3-1/2” sides being vertical.
Place a 1/4” (0,64 cm) thick spacer on top of the
rear 2 x 4 blocks. See Figure 43.
4. Adjust the front eyebolts until the chains are tight
and the deck is still resting on the 2 x 4’s. Tighten
jam nuts. See Figure 44.
5. Loosen the nuts and allow the rear of the deck to
rest on the 2 x 4’s and 1/4” spacers. Slide the
chains in the slots until the chains are tight and
tighten the nuts. See Figure 44.
6. Remove all 2 x 4 blocks and spacers from under
the mower deck.
Figure 44. Deck Level Adjustment
Troubleshooting, Adjustment & Service
Figure 43. 2 x 4 Locations
DECK LIFT SPRING
The deck lift springs (A, Figure 45) are factory set to
provide optimal lifting performance.
Although it is fastened with an adjustable anchor, this
is NOT AN ADJUSTMENT POINT.
DO NOT attempt to adjust the spring length or lifting
performance will be compromised.
Figure 45. Deck Lift Spring Location
A. Deck Lift Spring
A
Figure 42. Deck Height Pin Position