Filter
Top Products
31
Rider Troubleshooting Continued.
PROBLEM CAUSE REMEDY
Engine runs, but mower will 1. Transmission release lever(s) 1. Move into drive position.
not drive. in “neutral” position.
2. Belt is broken. 2. See Drive Belt Replacement.
3. Drive belt slips. 3. See problem and cause below.
4. Brake is not fully released. 4. See authorized service dealer
Transmission drive belt slips. 1. Pulleys or belt greasy or oily. 1. Clean as required.
2. Belt stretched or worn. 2. Replace belt.
Brake will not hold. 1. Internal brake disc on 1. See authorized service dealer
transaxle worn.
Mower steers hard or 1. Steering linkage is loose. 1. Check and tighten any loose connections.
handles poorly. 2. Improper tire inflation. 2. See Regular Maintenance Section.
TROUBLESHOOTING THE MOWER DECK
PROBLEM CAUSE REMEDY
Engine stalls easily with 1. Engine speed too slow. 1. Set to full throttle.
mower engaged. 2. Ground speed too fast. 2. Decrease Ground Speed.
3. Cutting height set too low. 3. Cut tall grass at maximum cutting
height during first pass.
4. Discharge chute jamming 4. Cut grass with discharge pointing toward
with cut grass. previously cut area.
Excessive mower vibration. 1. Blade mounting screws 1. Tighten to 70-90 ft.lbs. (94-120 N.m.).
are loose.
2. Mower blades, arbors, 2. Check and replace as necessary.
or pulleys are bent.
3. Mower blades are out 3. Remove, sharpen, and balance blades.
of balance. See Maintenance Section.
4. Belt installed incorrectly. 4. Reinstall Correctly.
Excessive belt wear or breakage. 1. Bent or rough pulleys. 1. Repair or replace.
2. Using incorrect belt. 2. Replace with correct belt.
Mower drive belt slips 1. Belt tension improperly adjusted. 1. Adjust belt tension. See Belt
or fails to drive. Replacement
2. Idler pulley spring broken or not 2. Repair or adjust as needed.
properly adjusted.
3. Mower drive belt broken. 3. Replace drive belt.
Troubleshooting, Adjustment & Repair
Not for
Reproduction