Filter
Top Products
31
Operation
CHECKING / ADDING FUEL (Diesel)
To add fuel:
1. Remove the fuel cap (A, Figure 13).
2. Fill the tank to the bottom of the fill tube. This will
leave room in the tank for fuel expansion. Refer to
your engine manual for specific fuel
recommendations.
3. Install and hand tighten the fuel cap.
4. Repeat same process for opposite tank.
NOTE: The fuel tanks are tied together through a
“tee” in the supply lines. By filling only one tank, the
level will balance between the two tanks, effectively
having 1/2 tank of fuel for each side. The fuel
transfer through the “tee” is slow, so it is
recommended that both tanks have fuel added to
them.
FUEL FILTER
This unit is equipped with two fuel filters. One is a
water separator/filter mounted to the frame, under the
seat and the other is located on the engine. The
water separator should be drained every 25 hours or
whenever water is visible in the bowl. Replace the
fuel filters every 500 hours of operation or as
required.
To drain the fuel filter:
1. Turn the engine off, set the parking brake, remove
the ignition key, and wait for all moving parts to
stop.
2. Allow the engine to cool for five (5) minutes before
draining the fuel filter.
3. Place a container under the drain valve (A, Figure
14) and turn the drain valve approximately 1-2
turns.
4. Allow the filter to drain until all water and debris
have drained out.
5. Turn the drain valve to close it when finished
draining.
WARNING
Diesel fuel is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do
not allow open flame, smoking or matches in
the area. Avoid over-filling and wipe up any
spills.
Do not drain or replace fuel filter when engine
is hot, as spilled fuel may ignite. Make sure the
filter drain valve is fully closed before returning
the unit to service.
Do not use Kerosene in place of diesel
fuel. Kerosene will damage the engine.
Consult the engine manufacturer’s manual
for specific fuel recommendations.
Figure 13. Fuel Tank Fill
A. Fuel Tank Cap
Figure 14. Drain Fuel Filter
A. Drain Valve
A
WARNING
Fuel leaked or spilled onto hot surfaces or
electrical components can cause a fire. To help
prevent possible injury, turn the ignition switch
off when changing fuel filters or water
separator elements. Clean up fuel spills
immediately.
The water separator is under suction
during normal engine operation. Ensure
the drain valve is tightened securely to
help prevent air from entering the fuel
system.
A
Operation