Filter
Top Products
www.ferrisindustries.com
Troubleshooting, Adjustment & Service
Figure 39. Deck Lift Pedal & Pin Position
Measure 1st
Measure 2nd
Measure 1st
Measure 2nd
Inner Rod
Outer Rod
Inner Rod
Outer Rod
Adjust Here
Figure 38. Measure the Inner & Outer Lift Rods
Figure 40. Adjust the Inner & Outer Lift Rods
Adjust Here
DECK LIFT ROD TIMING
ADJUSTMENT
1. Park machine on a flat, level surface. Disengage
the PTO, stop the engine and engage the parking
brake. Rear tires must be inflated to 15 psi (1,03
bar); front tires to 25 psi (1,72 bar).
2. To check the inner lift rod timing, measure and
record the distance between the inner lift pivots
and the inner rod pivots. Repeat for other side of
unit. See Figure 38.
3. To check the outer lift rod timing, measure and
record the distance between the outer lift pivots
and the outer rod pivots. Repeat for other side of
unit. See Figure 38.
4. If the measurements for the inner rods are equal,
and the measurements for the outer rods are
equal, no further adjustment is required. If the
measurements are NOT equal (greater than 1/8”
(3,17mm) difference), adjustment is required,
continue with Step 5.
5. Lock the deck lift pedal in the 5” (12,7cm) position.
Remove the cutting height adjustment pin and
lower the mower deck.
6. To ensure that the deck is in the lowest position,
push the pedal by hand towards the rear of the
unit and install the height adjustment pin in the 3”
(7.6cm) position to hold in place.
7. Block up the mower deck until all hanger chains
are slack.
8. Refer to Figure 40. To adjust the inner lift rod,
loosen the jam nut on the front ball joint then
remove the 1/2” hardware fastening the ball joint
the the lift pivot arm. Turn the ball joint clockwise
to shorten the distance between the rod pivots or
counterclockwise to lengthen the distance
between the rod pivots. Reinstall the ball joint on
the lift pivot arm and secure with the 1/2”
hardware previously removed. Tighten the jam nut
against the lift rod.
9. Refer to Figure 40. To adjust the outer lift rod,
loosen the jam nut on the front ball joint then
remove the 1/2” hardware fastening the ball joint
the the lift pivot arm. Turn the ball joint clockwise
to shorten the distance between the rod pivots or
counterclockwise to lengthen the distance
between the rod pivots. Reinstall the ball joint on
the lift pivot arm and secure with the 1/2”
hardware previously removed. Tighten the jam nut
against the lift rod.
10. Remove blocks from under the mower deck.
11. Remove the the cutting height adjustment pin from
in front of the deck lift pedal arm. Lift mower deck
and reinstall adjustment pin in desired mowing
height.
42
Troubleshooting