Not for
Reproduction
47
Figure 49. 2 x 4 Locations (Arrow points toward front
of the deck)
Figure 50. Hanger Chain Adjustment
A. Adjustment Points
Deck Leveling Adjustment
NOTE: Before adjusting the deck level, the deck lift
rod timing must be checked and/or adjusted.
Coarse Adjustment Procedure
When adjusting the deck level, the coarse adjustment
procedure should be used to make the majority of
the adjustment and the Fine Adjustment Procedure
should be used to complete the adjustment.
1. Park machine on a flat, level surface. Disengage
the PTO, stop the engine and engage the parking
brake. Rear tires must be inflated to 18 psi (1,24
bar); front tires to 25 psi (1,72 bar).
2. Lock the deck lift pedal in the 5” (12,7 cm)
position. Place the deck height adjustment pin in
the 4” position and lower deck the lift pedal until
the arm contacts the pin.
3. Place 2 x 4 blocks under each corner of the
mower deck with the 3-1/2” sides being vertical.
See Figure 49.
4. 52” Models Only: Loosen the nuts and allow the
front of the deck to rest of the 2 x 4’s. Slide the
chains down in the slots until the chains and tight
and tighten the nuts. See Figure 50.
4a. 61” Models Only: Adjust the front eyebolts until
the chains are tight and the deck is still resting on
the 2 x 4’s. Tighten the jam nuts. See Figure 50.
5. Loosen the nuts and allow the rear of the deck to
rest on the 2 x 4’s. Slide the chains down in the
slots until the chains are tight and tighten the nuts.
See Figure 50.
6. Remove all 2 x 4 blocks from under the mower
deck.
7. See Figure 51. Position the outside mower blades
so they face front-to-back.
8. Measure from the front tip of the blade from the
cutting edge to the ground. Measure from the
rear tip of the blade from the cutting edge to the
ground. Repeat this process for the other side of
the machine.
• The measurement should be 4” (10,2 cm).
Troubleshooting, Adjustment & Repair
CAUTION
Avoid injury! Mower blades are sharp.
Always wear gloves when handling blades or
working near blades.
A
A
A
Figure 51. Checking the Blade Height Adjustment
A
A
A
A
52” Models
61” Models