Filter
Top Products
Not for
Reproduction
30 www.ferrisindustries.com
Regular Maintenance
Battery Maintenance
Cleaning the Battery and Cables
1. Disconnect the cables from the battery, negative
cable first (B, Figure 20).
2. Clean the battery terminals and cable ends with a
wire brush until shiny.
3. Reinstall the battery and reattach the battery
cables, positive cable first (A)
4. Coat the cable ends and battery terminals with
petroleum jelly or non-conducting grease.
A
B
Figure 20. Battery Compartment
A. Positive (+) Cable & Terminal
B. Negative (-) Cable & Terminal
WARNING
Be careful when handling the battery. Avoid
spilling electrolyte. Keep flames and sparks
away from the battery.
When removing or installing battery cables,
disconnect the negative cable FIRST and
reconnect it LAST. If not done in this order, the
positive terminal can be shorted to the frame by
a tool.
Anti-Scalp Deck Casters
The anti-scalp deck casters (A, Figure 21) will aid in
preventing the mower deck from scalping or gouging
the turf while mowing or turning.
72” Models (S/N: 2014714094 & Below):
The casters can be adjusted in 1/2” (1,3 cm)
increments with the spacers (B). The desired position
is just below the leading edge of the deck.
IMPORTANT NOTE: These casters are not intended
to be in contact with the ground at all times. If you
are mowing at a low cut height, adjust the casters up
to prevent the casters from carrying the weight of the
deck.
61” Models (All) & 72” Models (S/N:2014714095 &
Above):
These casters are not adjustable.
A
C
B
B
Figure 21. Anti-Scalp Deck Casters
A. Deck Caster
B. Spacer
C. Lynch Pin