Filter
Top Products
5
ENGLISH
CDs, or DVDs
•Slide safety cover (L) to the right to expose the CD entry (M).
•Hold CD, or DVD at the edge and feed one at a time, straight into entry (M) releasing
when shredding begins. Shredder will stop when item has passed through entry. CDs
and DVDs will be shredded into small particles.
•Slide cover (L) to the left when done shredding media.
CAUTION:
Do not hold CD or DVD with finger through the center ring while feeding
into shredder.
To empty waste basket
If basket full light (H) is on, follow these steps until light turns off.
•Press control switch (E) to the off [O] position.
•Open the waste basket drawer (A) and remove full bag.
•Place new bag in basket, then slide drawer into cabinet (Fellowes plastic bag 36053).
•Press and hold control switch (E) in the reverse [R] position for a few seconds to clear
paper shreds that have collected under cutting cylinders.
•Alternate between automatic [I] and reverse [R] for a few seconds in each position.
CAUTION:
The shredder may be damaged if you alternate too rapidly between
automatic and reverse.
•Unplug shredder and remove wastebasket drawer (A).
– Carefully clear any paper shreds that have collected on under side of paper entry
(C).
CAUTION:
Confetti-cut shredders have exposed blades. Use care when remov-
ing paper shreds on underside of paper entry.
To clear a paper jam
If paper jam light (I) is on, follow these steps until light turns off.
•Check the waste basket and empty if full.
•Press and hold control switch (E) in the reverse [R] position to back paper out of paper
entry (C). Try pulling gently on paper to remove it from shredder.
•Alternate between automatic and reverse, if needed:
– Move control switch to automatic [I] and run for 1-2 seconds.
– Press and hold control switch (E) in the reverse [R] position for a few seconds.
– Continue alternating between automatic and reverse until the jam clears.
CAUTION:
The shredder may be damaged if you alternate too rapidly between
automatic and reverse.
Maintenance
Empty waste basket regularly
to ensure the smooth functioning of the cutting cylin-
ders. The shredder will not operate when the basket is full.
Oil regularly to ensure proper operation. If used at or near daily capacity, apply oil
every time you empty the basket. Use Fellowes Powershred Lubricant #35250 or
other non-aerosol vegetable-based oil in a long-nozzle container (sample oil
provided).
CAUTION:
Do not use flammable synthetic oil, petroleum-based products, or
aerosol lubricants of any kind.
To oil the cutting cylinders
•Apply oil over full width of cutting cylinders through the paper entry (C).
•Move control switch (E) to automatic [I] and run for 1-2 seconds.
•Press and hold the control switch (E) in reverse [R] for at least 3 seconds.
•Repeat the automatic/reverse sequence 3 or more times.
2
1
3