Filter
Top Products
Equipment Parts
1. Waste Paper Cover
2. Punching Area
3. Punching Handle
4. Margin Guide
Using the Punching
Machine
Punching Holes
1. Use the margin guide on the left-most side of the
punching area to align the sheets.
2. Slide all sheets to the back of the punching area.
NOTE: a maximum of 5 sheets can be punched at
a time.
3. Lower the punching handle to punch holes in the
paper.
4. Return handle to its original position and remove
sheets from punching area.
5. Repeat until all sheets and covers have been
punched.
Binding the Document
Use the table below to select the appropriate plastic
coil according to the number of sheets to be bound:
No. of Sheets
Coil Size
30 6 mil
45 7 mil
70 10 mil
85 13 mil
1. Align holes. Place document to be bound on
desktop. Starting at the first hole on either end,
twist binding coil until it has passed through every
hole. (Figure A) 2. Close loop by bending end of
coil down towards binding on each end of the
document. (Figure B). Your document is now
bound.
Emptying Paper Cuttings
To remove, simply raise the waste paper cover located
on either side of the machine. Pick up machine and
tip it toward the same side as the raised cover. To be
sure all paper clippings have been removed from the
machine, gently shake the machine. To prevent
clogging and jamming, be sure to empty paper
clippings frequently.
A
B
C
®
PC100
1
2
3
4
Figure A
Figure B