Filter
Top Products
PRODUCT MAINTENANCE
All shredders require oil for peak performance. If not oiled, a machine may experience
diminished sheet capacity, intrusive noise when shredding and could ultimately stop
running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
OILING SHREDDER
*Apply oil
across entry
Set to Reverse (R) 2-3
seconds
Set to Off (O)
15
CLEANING AUTO-START INFRARED SENSORS
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Paper detection sensors are designed for maintenance free operation. However,
on rare occasions the sensors may become blocked by paper dust causing the
motor to run even if there is no paper present (Note: two paper detection sensors are
located in the center of the paper entry).
Turn off and unplug
shredder
Locate Auto-start
infared sensor
Clean any contamination
from the paper sensors
Use thin, long-handled brush
to clean sensors. Make sure
brush is clean and dry
TO CLEAN THE SENSORS
SHEET CAPACITY SENSOR
Eliminates frustrating jams by preventing overloads.
Electronically measures paper thickness to prevent
paper jams:
R
R
R
R
R
R
R
Up to RED: Too many sheets have been
inserted. Automatic reverse of paper.
Up to YELLOW: Maximum sheet capacity.
Up to GREEN: Normal sheet capacity
during shredding process.
R
R
R
R
R
R
R
1
R
R
R
R
R
R
R
3
R
R
2
15
*Only use a non-aerosol vegetable oil in long nozzle
container such as Fellowes 35250
1
R
R
2
R
R
3
R
R
4
ADVANCED PRODUCT FEATURES
SilentShred™
Technology
SilentShred™ noise quality
shreds without noisy disruptions
Sheet Capacity Sensor
Helps prevent paper jams
by indicating sheet capacity
levels during the shredding
process
Safety Shield
Electronically controlled
shield stops shredder
when opened for
advanced safety
Auto Shut Off
After 30 minutes of
inactivity, shredder
automatically turns off for
zero energy consumption
30
TROUBLESHOOTING
R
R
R
R
R
R
R
R
When flashing blue,
too much paper is
inserted. Shredder
will automatically stop
and reverse paper
Gently pull uncut paper
from paper entry
1
Shred 1 sheet of
paper to clear
cutters. Resume
normal shredding
PAPER JAM
R
R
R
R
R
R
R
R
3
If necessary, press
Reverse (R) to run
shredder in reverse and
then pull uncut paper
from shredder
Overheat Indicator: When flashing alternatively with On/Off
( )
LED, shredder requires a 10-15, minute cool down period. When
( )
is blue, resume shredding
Safety Shield Indicator: When flashing alternatively with On/Off
( )
LED, safety shield is open and shredding will stop. To resume shredding, make sure safety shield is closed.
Door Open Indicator: When flashing alternatively with On/Off
( )
LED, safety shield is open. To resume shredding, make sure the door is closed.
Paper Capacity Indicator: When flashing blue, too much paper is inserted. Shredder will automatically stop and reverse paper. See Paper Jam section below.
Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 3604101.
R
R
R
R
R
R
R
R
R
R
R
R
R
R
R
R
R
R
R
2
R
R
4