OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS
4. Insert the handle into the handle
bracket and secure with the two (2)
screws provided. (Fig. 4)
Assembling the Pressure Washer
Trolley (cont)
Fig. 4
5. Slide the top brace over the legs and
insert the handle assembly onto the
top of the legs. Secure the handle
assembly to the legs with the two (2)
screws provided. (Fig. 5)
Fig. 5
6. Slide the top brace down the legs
until it reaches the top of the
pressure washer. Secure the top
brace to the pressure washer unit
with the two (2) screws provided.
(Fig. 6)
Fig. 6
7. To attach the wheels to the support
brackets, just push them in until they
lock in place. (Fig. 7)
Fig. 7
8. To attach the front support to the
pressure washer unit, place it under
the front of the unit in the mark
provided. Push it in until it snaps into
place. Then secure it to the pressure
washer with the screw (1) provided.
(Fig. 8)
Fig. 8
9. When the unit is finally assembled, it
should look like the illustration below.
(Fig. 9)
Fig. 9
5
Once all the desired attachments and
the high pressure hose are attached to
the pressure washer, you can connect
the garden hose to the unit.
1. Attach the male adapter (supplied) to
the water intake connector on the left
hand side of the unit. (Fig. 13)
2. Attach the female hose coupling to
the garden hose. (Fig. 13)
3. Connect the female hose coupling to
the male adapter making sure that it
is tightly secured in place. (Fig. 13)
Fig. 13
4. After all the connections have been
and
BEFORE you plug the pressure
washer into an electrical outlet, open
the water supply and press on the
trigger switch in order to remove any
air which may be in the hose or
pump. Continue to press on the
trigger switch until you get a constant
flow of water coming out of the trigger
gun. Allow water to flow for 30
seconds.
5. Once this is accomplished, stop
pressing the trigger switch. Engage
the safety lock on the trigger
6. Ensure that the "On/Off" switch, at
the rear of the unit, is on the "Off"
position, then plug the unit into an
electrical outlet and turn the unit to
the "On" position.
7. Now you are ready to use the
pressure washer. Disengage the
safety lock and depress the trigger on
the trigger gun.
Low
pressure
water inlet
3. Once the high pressure hose is
connected to the trigger gun, you can
attach any of the lances and
accessories that you desire. To
attach either of the lances or the
brush to the trigger gun, hold the
trigger gun in your left hand insert the
desired lance or the brush and push
it in all the way into the connector on
the trigger gun and turn it clockwise
60° until it locks in place. To remove
the attachment, push down on the
attachment and turn counter-
clockwise 60° and then pull out.
Make sure that the attachments are
securely locked in place before use.
(Fig. 12)
Fig. 12
2. Then attach the other end of the high
pressure hose to the high pressure
hose connector on the trigger gun.
(Fig. 11)
Fig. 11
Once the pressure washer is
assembled to the trolley, you are ready
to use the unit.
1. While facing the front side of the unit
attach the high pressure hose to the
high pressure output connector on
the right side of the unit. Twist on
tight to avoid leakage. (Fig. 10)
Fig. 10
High
pressure
output fitting
Attaching High Pressure Hose to
Pressure Washer
Garden Hose Connection
6
