Famous Trails MD9200 Metal Detector User Manual


  Open as PDF
of 2
 
EASY ASSEMBLY
MD9200 assembly is easy, and it requires no special
tools.
The only assembly required is to attach the search
coil and lower stem to the upper stem and on to the
control box. Fresh batteries can then be installed, and
the detector will be ready for use.
Please use the following steps for assembly:
1.Depress the button on the single stem, and push it
into the hole on the stem below the control panel.
(Fig. A&B)
2. Depress the adjustment button on the lower stem.
(Fig. A&B)
3.Push the lower stem into the appropriate holes of
the upper stem to fit the height of the person using the
detector. (FIG. A&B)
4.Release the assembly knob/bolt of the lower stem.
5.Insert the lower stem into the mount of the search coil.
(Fig.C)
6.Fasten the knob/bolt.
7.Wind the search coil cable around the stem and fasten it with bolt
the end into the control panel attached. Caution:
Provide enough slack in the cable near the search coil
angle. (Fig. D)
Fig.B
Fig C
 previous