Filter
Top Products
- 17 -
FIGURE 4
DRIVE LEVER, NEUTRAL LOCK LATCH OPERATION
4.3.4 Drive Wheel Engagement/Turning: With drive levers locked in neutral, shift
speed control lever to desired forward speed. Slowly squeeze and hold both
drive levers in the neutral position and rotate both neutral lock latches
from the neutral lock position to the forward position.
For straight ahead motion: Smoothly release both drive levers to engage drive
wheels.
For turning: Squeeze the right hand drive lever to turn right and the left hand
drive lever to turn left. To make a “zero turn”, squeeze either the left hand or
the right hand drive lever back into the reverse position while the opposite drive
lever is in a forward position at an equal but opposite speed.
For reverse: Squeeze both drive levers into the reverse position (See Figure 4).
For smooth operation of this machine, avoid quick, jerky movements of the
drive levers. Move the drive levers smoothly and deliberately.
4.3.5 To Stop: Squeeze drive levers back to the neutral position. Move the neutral
lock latches into the neutral lock position and release drive levers. Move the
speed control lever to the neutral position.
4.3.6 Engaging PTO: The PTO switch engages the cutting blades. Be sure that all
persons are clear of mower deck and discharge area before engaging the PTO.
Set throttle to “midway” position. The switch must be pulled out to the “Rotate’
position to engage the blades. Accelerate to full throttle to begin mowing.
4.3.7 Stopping PTO: The switch is pushed in to the “Stop” position to stop the blades.
(a) (b)
(c) (d)