Filter
Top Products
4
Safety and Instruction Decals
Safety decals and instructions are easily visible to the operator and are located near any
area of potential danger. Replace any decal that is damaged or lost.
On Control Panel
(Part No. 63-9060)
On Mower Housing
(Part No. 43-8480)
On Control Panel
(Part No. 100-3282)
On Belt Cover
(Part No. 74-1970)
On Discharge Tunnel
On Belt Cover
(Part No. 52-2620)
On Plug
(Part No. 93-7398)
(Part No. 76-2110)
On Handle
(Part No. 104-1329)
Assembly
Note: Determine the left and right sides of the machine
from the normal operating position.
Installing the Handle
1. Mount the handle to the outside of the lawn mower
housing (using the bottom hole) with two 5/16–18 x
1–1/4 in. (8 mm x 31 mm) cap screws, washers, and
thin nylon insert locknuts.
2. Secure the handle latches to the handle with two
5/16–18 x 1-1/2 in. (8 mm x 38 mm) cap screws,
washers, and nylon insert locknuts (Fig. 1).
m-3850
1
3
4
6
2
5
Figure 1
1. Bag support rod
2. Carriage bolt
3. Bag aligning plate
4. Cap locknuts
5. Handle
6. Handle latch