Filter
Top Products
27
cap is completely seated by pressing down firmly while turning until the cap
stops. Once the cap is installed, the engine may be stopped.
4.1.11 Check hydraulic oil level
:
Service Interval: 40 hr.
a) Stop engine and wait for all moving parts to stop.
b) Tilt seat up.
c) Clean area around hydraulic reservoir cap and remove cap. Oil level should be
to the top of the baffle inside the tank. If not, add oil. Use only Mobil 1 15W-
50 synthetic motor oil. Replace hydraulic reservoir cap and tighten until snug.
Do not overtighten.
NOTE: The baffle is labeled “HOT” and “COLD”. The oil level varies with the
temperature of the oil. The “HOT” level shows the level of oil when it is at
225°F (107°C). The “COLD” level shows the level of the oil when it is at 75°F
(24°C). Fill to the appropriate level depending upon the temperature of the oil.
For example: If the oil is about 150° F (65°C), fill to halfway between the
“HOT” and “COLD” levels. If the oil is at room temperature (about 75° F
(24°C)), fill only to the “COLD” level.
4.1.12 Check auxiliary hydraulic oil level
:
Service Interval: If there is evidence of a leak or the hydraulic
cylinder does not perform normally.
a) Retract the hydraulic cylinder.
b) Stop engine and wait for all moving parts to stop.
c) Tilt the seat forward.
d) Locate the auxiliary hydraulic power unit reservoir. See Figure 5.
FIGURE 5
e) Clean area around the reservoir plug and remove. Oil level should be up to
the reservoir plug hole. If not, add oil. Use only Mobil 1 15W-50 synthetic
motor oil. Replace reservoir plug and tighten until snug. Do not
overtighten.
4.1.13 Check tire pressures
:.
Service Interval: 40 hrs.
a) Stop engine, wait for all moving parts to stop, and remove key. Engage
parking brake.
b) Check tire pressure in drive tires.
c) AT101 (Bar Lug) drive tires should be inflated to 9 psi (62 kpa).
d) Turfmate drive tires should be inflated to 13 psi (90 kpa).
e) The rear caster tires are semi-pneumatic and do not need to be inflated.