Filter
Top Products
33
FIGURE 10
h) Move the motion control levers to the reverse position. Return the motion
control levers to neutral. The wheels must stop turning (or slightly creep in
reverse).
i) Stop engine and wait for all moving parts to stop. Remove jumper wire from
wire harness connector and plug connector into seat switch.
j) Lower from jackstands.
4.2.6 Weight transfer spring adjustment
:
Weight transfer springs are assembled from the factory to apply the maximum
amount of weight onto the drive wheels. This setting provides the greatest
amount of traction. Some conditions may require the rear wheel lift to be
reduced. This can be done by reducing the amount to weight transfer, which will
increase the amount of weight on the front and rear castors.
a) Rotate the left motion control arm up and into the operation position.
b) Locate and loosen the knob under the rear of the left fender. See Figure 11.
FIGURE 11
c) Slide the fender forward and twist upward and outward to remove.
d) To adjust the weight transfer springs, fold the mower deck and front frame
and lock in service position. See Deck Manual for complete instructions.