Filter
Top Products
17- ENG
D27935
ENGINE
Consult the Engine Owners Manual for the manufacturer's recommendations for
storage.
PUMP
It is recommended that you follow these steps to protect the internal seals of the
pressure washer when STORING THE UNIT FOR MORE THAN 30 DAYS AND/OR
WHEN FREEZING TEMPERATURES ARE EXPECTED.
The manufacturer recommends using EXA80 Pump Saver/Winterizer. EXA80
Pump Saver/Winterizer may be purchased in stores where Excell pressure
washers are sold. If EXA80 is not available, *RV antifreeze needs to be run
through the pump as outlined in the steps below.
1. Obtain a funnel, six ounces of *RV antifreeze, and approximately 36 inches
of garden hose with a male hose connector attached to one end.
Use only RV antifreeze. Any other antifreeze is corrosive
and can damage pump.
2. Disconnect spark plug wire.
3. Disconnect high pressure hose from pump and from spray gun.
4. Connect 36 inch length of hose to water inlet of pump.
5. Add *RV antifreeze to hose as shown.
6. Pull engine starter rope slowly
several times until antifreeze comes
out of high pressure hose connection
of pump.
7. Remove short hose from water inlet of
pump.
8. Reconnect spark plug wire.
9. Drain all water from high pressure
hose, coil it, and store it in cradle of
the pressure washer handle.
10. Drain all water from spray gun and wand by holding spray gun in a vertical
position with nozzle end pointing down and squeezing trigger. Store in
gun/hose holder.
11. Store chemical hose, high pressure hose, spray gun, and wand so they are
protected from damage, such as being run over.
*Windshield washer fluid may also be used.
STORAGE