Filter
Top Products
6- ENG
A13548
ASSEMBLY INSTRUCTIONS
3. Connect wand to gun. Tighten
securely.
2. Attach high
pressure hose
to gun. Tighten
securely.
1. Place handle assembly onto frame,
depress the snap buttons, and
slide the handle assembly onto the
frame until snap buttons snap into
place.
CARTON CONTENTS
Engine Frame and
Wheel Assembly
High Pressure
Hose
Spray Gun
Quick Connect Spray Wand
Handle
Chemical
Hose
Bagged Parts
Nozzle
Cleaning
Tool
Engine
Manual
Quick
Connect
Nozzles
Nozzle
Holder
4. Place the nozzle holder onto
the panel (located on the handle
assembly) and push each nozzle
holder into place.
5. Remove five colored quick
connect nozzles from plastic
bag and insert them into correct
grommet on the nozzle holder.
NOTE: Nozzles are color coded
to match colored nozzles on
panel.
The shipping plug
must be removed
and replaced with the dipstick/oil
plug before operating pressure
washer.
6. Using a 7/8" wrench,
remove shipping plug
from pump by turning
it counterclockwise.
Discard plug.
7 Remove dipstick/oil plug from
plastic bag and install into pump,
tighten securely.
NOTE: The high pressure pump was
filled with oil at the factory. There is no
need to add oil at this time, see the
Maintenance section of this manual
for Maintenance information.
English/
Spanish
Operation
Manual
Registration
card