Using the High Pressure lance
The high pressure lance may be used
alone or with the detergent applicator
bottle.
Add detergent to the bottle and then
attach the detergent applicator bottle to
the high pressure lance, just push it on
the end of the high pressure lance.
(Fig. 6 & 7) To remove the detergent
applicator bottle, lift the tab on the top
of the connector and pull off.
Fig. 5
Safety
Lock
Fig. 6
OPERATING INSTRUCTIONSOPERATING INSTRUCTIONS GETTING TO KNOW YOUR PRESSURE WASHER
CAUTION
Lubrication: The pressure washer is
supplied with a closed lubrication
system, so no addition of oil is needed.
Checking the Water Intake Filter
: The
water intake filter is located inside the
water intake connector. (Fig. 8)
Remove periodically and inspect for
any deposits that might accumulate
there.
Fig. 8
Hose Connector
Water Intake
Maintenance & Cleaning
When you wish to stop using the
pressure washer temporarily, make
sure that the safety lock has been
engaged to avoid any accidental
operation. (Fig. 5)
Cleaning the Nozzles: If you notice that
the output pressure fluctuates, you may
have to clean the nozzles. Turn the unit
"Off". Unplug from electric outlet and
disconnect the water supply. Remove
the lance and hose with the trigger gun
from unit. Take the small metal pin
provided and insert into the nozzle end
to remove any obstructions. (Fig. 9)
Fig. 9
This will occur more frequently if your
water supply is very hard.
CAUTION
1. Pressure Washer
2. On/Off Switch
3. High Pressure Water Output
4. Handle
5. Water Intake With Filter
6. Wheels (x2)
7. High Pressure Lance
8. Brush
9. Trigger Gun
10. Safety Lock
11. Trigger
12. High Pressure Hose
13. High Pressure Hose Connector
14. Detergent Applicator Bottle
15. Garden Hose Coupling
When using your pressure washer,
always have it in the horizontal
position as shown below. NEVER
have it in the upright position.
Fig. 7
Illustrations may differ from actual product.
Technical Specifications
Voltage: 120V., 60Hz.
Power: 12.5 Amps.
Pressure: 1450 psi. (max)
Flow Rate: 1.45 gpm
6
3