ETA Systems ETA C15D Yard Vacuum User Manual


  Open as PDF
of 12
 
– 8 – ETAsys.com
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
ETA-C15D
Power Conditioner
REAR PANEL FEATURES
1. AC Mains Input–Connectthe9'(3m)powercordtoa15A120VACoutlettoprovidepowertotheETA-C15D.
2. AC Filtered Outlets–ThefiveACoutletsare“Live”whenthepowerswitchisactivated.Theseoutletsarerecommendedfor
products such as Computers, Modems, Routers, DSP Processors, Cable/SAT, DVD, or CRT TVs. These outlets have a special filter
circuit that is optimized to reduce interference to your Digital and Analog components. The total maximum draw for this section is
10A and the total current draw for the ETA-C15D is 15A.
3. AC High Power Outlet–Thisoutletisdesignedtodelivermaximumcurrenttopowerhungrycomponentslikeamplifiersand
projectors. It does not harm low power consuming components when connected to this outlet.
4. Unswitched AC Outlet–This120VACoutletisalwayslivewhentheETA-C15DpowercordispluggedintoanACmainspower
source and voltage is present. If voltage is present at the outlets it will be displayed on the AC Mains Meter. Note: The AC mains
power switch does not affect the Unswitched AC Outlets. The Unswitched Outlets are protected by the surge protection circuitry
but will not be shut off by the EVS circuit.
5. XLR Light Socket–A12VDCXLRlightsocketprovidespowerfortheoptionalAL-GNL18light.
6. Light Socket Power Switch–ThisswitchturnstheXLRlightsocketOn/Off.
Installation
BeforeinstallingwestronglysuggestyoureadtheentiremanualtoensureyoubenefitfromallthefeaturesoftheETA-C15D.The
ETA-C15D can be placed on a shelf or rack mounted in a standard 19" width rack. When mounting to a rack rail system use
10
⁄32" x 1".
Placementwithinarackisnotcriticalbuttherackshouldbewithin6'ofadedicated15AACoutlet.Alwaysmakesurethe15Aoutlet
isproperlyinspectedbyacertifiedelectricianpriortoconnectingtheETA-C15D.Belowareafewinstallationtips.
• AfterpluggingtheETA-C15Dintoa15AACMainsoutletinspecttheWiringFaultLEDforillumination.TheLEDshouldnotbeon.
• InspecttheequipmentthatistobepluggedintotheETA-C15Dtoensureitdoesnotexceed15Atotalamperagedraw.
• Dividetheequipmentintotwocategories.Picktheoutletsthatmatchtheoutletsequipmentuse.
156 2 3 4
 previous next