Filter
Top Products
6. Carefully slide the motor ring up the
motor housing and position the ring so
that the reverse switch slot in the ring is
in the correct position (Figure 5).
NOTE: Careful not to scratch ceiling
fan assembly while positioning the
motor ring in place.
7. Secure the motor ring to the motor
housing assembly using the three
#8-32 x .25” flat head screws supplied
(Figure 5).
SUPPLY GROUND
BLACK
WIRES
WHITE WIRES
#
8-32 X .25" FLAT
H
EAD SCREW (3)
REVERSE SWITCH
MOTOR RING
MOTOR
HOUSING
Figure 5
To avoid possible fire or shock, make
sure that the electrical wires are
completely inside the outlet box and not
pinched between the ceiling cover and
the ceiling.
!
WARNING
To reduce the risk of personal injury, do
not bend the blade flange when installing
the blades, balancing the blades or
cleaning the fan. Do not insert foreign
objects in between rotating fan blades.
!
WARNING
1. With the fan suspended on the ceiling,
position a blade on top of the ceiling fan
blade flange by aligning the raised
bosses into the blade mounting holes.
Carefully position the blade medallion
onto the blade by aligning its bosses
with the blade holes. Install three #10-
32 x .75” oval head screws into the
mounting holes of the medallion and
securely tighten each screw (Figure 6).
If using wooden blades, be very careful
not to over tighten the blade screws.
NOTE: Screws for the wooden blades
are shipped with the blades. Do not
discard the blade packaging until you
have located the screws.
NOTE: Recommend the blades screws
be checked regularly for tightness.
Check to see that all connections are
tight, including ground, and that no bare
wire is visible at the wire connectors,
except for the ground wire. Do not
operate fan until blades are in place.
Noise and fan damage could result.
!
WARNING
To avoid possible fire or shock, do not
pinch wires between the hanger
ball/downrod assembly and hanger
bracket.
!
WARNING
2. Securely connect the fan motor white
wire to the supply white (neutral) wire
using wire connector supplied
(Figure 4).
3. Securely connect the fan motor black
wire to the supply black (hot) wire using
wire connector supplied (Figure 4).
Blade Installation
Figure 4
6
Model No.: CF3400
4. After connections have been made,
separate the white and green wires
from the black wires.
5. Carefully turn the wires upward and
insert them up through the center
opening of the ceiling cover and into
the outlet box. Push the green and
white wires into one side of the outlet
box; push the black wires into the other
side of the the outlet box.
BP7386, CF3400 Corsair 11/25/09 6:20 AM Page 6