Emerson CF2000WB02 Outdoor Ceiling Fan User Manual


 
4
1. Remove the fan motor and housing assembly from
styrofoam packaging and position it so that the top
of the motor is facing you.
2. Separate, untwist and unkink the three motor
leads. Route the motor leads through the hanger
ball/downrod assembly and seat the downrod in the
motor coupling (Figure 1).
3. Align the clevis pin holes in the downrod with the
holes in the motor coupling. Install the clevis pin
and secure with the hairpin clip (Figure 2). (Pin and
clip are supplied in loose parts bag.) The clevis pin
must go through the holes in the motor coupling
and the holes in the downrod. Push the straight leg
of the hairpin clip through the hole near the end of
the clevis pin until the curved portion of the hairpin
clip snaps around the clevis pin. The hairpin clip
must be properly installed to prevent the clevis pin
from working loose. Pull on the hanger ball to make
sure the clevis pin is properly installed.
4. Install the setscrew (supplied) in the motor
coupling (Figure 2). While pulling up on the hanger
ball, tighten the setscrew using the setscrew
wrench (supplied).
NOTE: The setscrew must be properly installed as
described above, or fan wobble could result.
5.Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 3). Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in step 8.
6.Screw two 1” threaded studs (supplied) into the
motor (Figure 4). Leave approximately 7/8” of the
stud extending above motor. Slide the motor cover
over the downrod and rotate the cover until the
threaded studs protrude; install two lockwashers
and knurled knobs (supplied) to secure the cover.
NOTE: Make sure the connected red leads, the
connected brown leads, and the white lead are
completely inside the motor cover and not
pinched between the motor cover and the motor.
7.Position the ceiling cover over the downrod. Be sure
the cover is oriented correctly, with the large
opening at the top (Figure 5).
MOTOR
COUPLING
CLEVIS PIN
HAIRPIN
CLIP
SETSCREW
CONNECTED
RED LEADS
CONNECTED
BROWN LEADS
WHITE LEAD
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
HANGER BALL
Assembly Instructions
HANGER BALL
PIN
DOWNROD
SETSCREW
MOTOR COVER
KNURLED KNOB
1" THREADED ST
U
7/8"
LOCKWASHER
MOTOR
MOTOR LEADS
(BLACK, WHITE,
AND BLUE)
MOTOR
COUPLING
FAN MOTOR AND
HOUSING ASSEMBLY
HANGER BALL/
DOWNROD ASSEMBLY
DOWNROD
PIN
HANGER BALL
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrew securely
tightened. Failure to verify that the pin and setscrew
are properly installed (as shown in Figure 2) could
result in the fan falling.
WARNING
!
Figure 1
Figure 3
Figure 4
Figure 5
Figure 2