Filter
Top Products
6
3. Screw the two 1-1/4” threaded studs (supplied) into
the tapped holes in the hanger bracket (Figure 10).
4. Lift the ceiling cover up to the threaded studs and
turn until studs protrude through the holes in the
ceiling cover (Figure 10).
5. Secure the ceiling cover in place by sliding
lockwashers (supplied) over the threaded studs and
installing the two knurled knobs (supplied).
(Figure 10.) Tighten the knurled knobs securely until
the ceiling cover fits snugly against the ceiling and
the hole in the ceiling cover is clear of the downrod.
Your fan is now wired to be turned on and off from
the fan
switch.
Installing Fan Blades
1. Use four 10-32 x 3/8” pan head screws and flat
washers (supplied) to secure the flange to the fan
blade (ordered separately) (Figure 11). Repeat for
the remaining four blades.
CEILING COVER
LOCKWASHER
KNURLED KNOB
1-1/4"
THREADED
STUD
Figure 10
How to Wire Your
Ceiling Fan
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
1. Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the grounding conductor of supply (this
may be a bare wire or wire with green colored
insulation) (Figure 9). Securely connect wires with
wire connector supplied.
NOTE: If you are using an Emerson Light Fixture
with your fan, see Light Fixture Owner’s Manual
for wiring.
2. Securely connect the fan motor white wire to the
supply white (neutral) wire using wire connector
supplied (Figure 9). Securely connect the fan motor
black wire and blue wire to the supply black (hot)
wire using wire connector supplied (Figure 9). After
connections have been made, turn leads upward
and carefully push leads into the outlet box, with
the white and green leads on one side of the outlet
box and the black and blue leads on the other side
of the outlet box.
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is ground-
ed, contact a licensed electrician for advice, as it
must be grounded for safe operation.
WARNING
!
NOTE: CEILING COVER
OMITTED FOR CLARITY.
GROUND
WIRE
LISTED
WIRE
CONNECTOR (3)
GREEN WIRE
(GROUND) FROM
HANGER BRACKET
GREEN WIRE
(GROUND) FROM
HANGER BALL
WHITE SUPPLY
(NEUTRAL)
WHITE FAN
WIRE
BLACK SUPPLY
(HOT)
BLACK AND BLUE
FAN WIRES
Figure 4
Figure 9
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
WARNING
!
10-32 x 3/8"
PAN HEAD SCREW
FLAT WASHER
FAN BLADE
BLADE
FLANGE
Figure 11
SUPPLY
GROUND
WIRE