EMAK MT3600 Chainsaw User Manual


 
9
en
SAFETY RULES
As an additional safety precaution, apply the chain brake prior
to setting down the saw.
Only use the chain saw in well-ventilated places, do not opera-
te the chain saw in explosive or flammable atmospheres or in
closed environments (Fig. 12). Beware of carbon monoxide poi-
soning.
Do not operate saw from a ladder or in a tree. Always cut from
a firm-footed and safe position.
Do not put pressure on the saw at the end of the cut. Applying
pressure can cause you to lose control when the cut is com-
pleted.
Do not cut near electric cables.
Keep the handles dry, clean, and free of oil or fuel mixture.
When the chain saw is running, grip the front handle firmly with
your left hand and the back handle with your right hand (Fig.
10).
When cutting a limb that is under tension, be alert for spring-
back so you will not be struck when the tension in the wood
fibre is released.
Take great care when cutting small branches or shrubs which
can block the chain, be thrown back towards you or cause you
to lose your balance.
Never cut with the chain saw above shoulder height (Fig. 13).
Never start up the chain saw without the chain cover fitted.
Precautions Against Kickback
WARNING: Avoid kickback which can result in
serious injury. Kickback is the backward, upward or
sudden forward motion of the guide bar occurring
when the saw chain near the upper tip of the guide
bar contacts any object such as a log or branch, or
when the wood closes in and pinches the saw chain
in the cut. Contacting a foreign object in the wood
can also result in loss of chain saw control.
Rotational Kickback can occur when the moving chain con-
tacts an object at the upper tip of the guide bar. This contact
can cause the chain to dig into the object, which stops the chain
for an instant. The result is an extremely fast, reverse reaction
which kicks the guide bar up and back toward the operator
(Fig. 14-15 and Fig. 16 page 10).
Pinch-Kickback can occur when the wood closes in and
pinches the moving saw chain in the cut along the top of the
guide bar and the saw chain is suddenly stopped. This sudden
stopping of the chain results in a reversal of the chain force
used to cut wood and causes the saw to move in the opposite
direction of the chain rotation. The saw is driven straight back
toward the operator.
Pull-In can occur when the moving chain contacts a foreign
object in the wood in the cut along the bottom of the guide bar
and the saw chain is suddenly stopped. This sudden stopping
pulls the saw forward and away from the operator and could
easily cause the operator to lose control of the saw.
Avoid Pinch-Kickback:
Be extremely aware of situations or obstructions that can cause
material to pinch the top of or otherwise stop the chain.
Do not cut more than one log at a time.
ƽ
11
12
13
14
15