Filter
Top Products
4
Before starting your Hedgetrimmer.
1. Form a loop in mains cable and push the
loop through the hole in the handle as
illustrated in Fig. B.
2. To secure, position the loop over the hook
and pull back as illustrated in Fig. C.
3. Connect to mains and switch on
4. Remove blade cover/storage holder as
illustrated in Fig. D.
To start your Hedgetrimmer
1. There are two switch levers fitted to your
Hedgetrimmer.
2. Both switch levers need to be held in the
operating position (See Fig E) for the
product to start.
To stop your Hedgetrimmer
• Move Hedgetrimmer away from cutting
area before stopping.
1. To stop, release one
of the switch
levers.(Fig F)
Starting and Stopping
B C
D
E
F
How to Use
How to Use your Hedgetrimmer
1. Inspect area to be cut before each use -
remove objects which can be thrown or
become entangled in the cutting blades.
2. Always keep the Hedgetrimmer in front of your
body. Hold handle firmly with both hands and
stand in a secure and stable position.
3. Allow the cutting blades to reach full speed
before entering the material to be cut.
4. Always work going away from people and solid objects
such as walls, large stones, trees, vehicles etc.
5. If blade stalls, immediately stop the
Hedgetrimmer. Disconnect the Hedgetrimmer
from the power source and clear jammed
debris from the cutting blades. Inspect blades
and repair or replace as needed.
Top Cutting
Use a wide sweeping motion. See Fig. G. A
slight downward tilt of the cutting blades in the
direction of motion gives the best cutting results.
Side Cutting
When trimming the sides of the hedge, begin at the
bottom and cut upwards (See Fig. H), tapering the
hedge inward at the top. This shape will expose more
of the hedge, resulting in more uniformed growth.
G
H