Filter
Top Products
3
Installing Kick Guard
1. Install bolt (A) in rear hole (B) of Kick Guard and
through front hole (C) in guide bar.
2. IMPORTANT: Dimple in Kick Guard (D) must
engage recess in guide bar (E).
3. Tighten nut (F) and bolt (A) until snug. Make
certain Kick Guard is flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard is tight on
guide bar.
1. Install bolt (A) in front hole (B) of Kick Guard
and through front hole (C) in guide bar.
2.
IMPORTANT: Dimple in Kick Guard (D) must
engage recess in guide bar (E).
3. Tighten nut (F) and bolt (A) until snug. Make
certain Kick Guard is flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard is tight on
guide bar.
SYMMETRICAL
Tools Needed: Two (2) 11 mm (7/16 in.) Wrenches
For saws with Kick Guard P/N 28949 and
symmetrical or asymmetrical low-kick type
guide bars.
SYMMETRICAL
For saws with Kick Guard P/N 28932 and
symmetrical low-kick type guide bars.
ASYMMETRICAL