Filter
Top Products
Grass Trimmer/Brush CuTTer
25
OperatOr's Manual
.080 (2.0 mm) dia. – 20’ (6 m)
.095 (2.4 mm) dia. – 20’ (6 m)
1. Cut one piece of line to recommended length.
nylon lIne replaCemenT
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of trimmer line into an eyelet, and push line equal
distance through trimmer head.
4. Hold trimmer head while turning knob clockwise to wind line onto
spool until about 5” (13 cm) of each line remains exposed.
Trimmer head is now fully loaded and ready for operation.
nylon lIne dIsassembly InsTruCTIons
NOTE
For normal use, Speed Feed head disassembly is not necessary.
However, if circumstances require disassembly, follow these
instructions.
1. Press top of locking tabs (A) on both sides of Speed Feed head to
release cover (B) from eyelet carrier(C).
2. Remove cover from eyelet carrier.
A
B
C
Wear
Indicators
Wear
Indicators
IMPORTANT
When the wear indicators located at the bottom of the Speed-Feed
head are worn smooth, replacement of the cover or the entire
Speed-Feed head is required.