Filter
Top Products
14 X7504083607
© 9/2014 ECHO Inc.
ASSEMBLY TC-210
ASSEMBLY
1. Support powerhead assembly upright on tines. Place top
handle assembly to rear.
Note: Make sure inside curves at handle ends are facing each
other.
2. Loosely assemble lower handles using short 1/4 in. x 3 in.
long hex head shoulder bolt (A), eye plates (B), lockwasher
(C), and locknut (D) in front handle end mounting hole as
shown.
3. Slide lower handle assembly under power head and throttle
linkage/ignition wires, and position in mounting groove.
4. Assemble using long 1/4 in. x 3-1/4 in. hex head shoulder
bolt (E), eye plate (B), lockwasher (C), and locknut (D) in
rear handle mounting holes. DO NOT TIGHTEN BOLTS.
5. Slide plastic carry handle onto lower handle tubes.
6. Remove (2) 1/4 " x 1-1/4" carriage bolts (F), (2) 1/4"
lockwashers (G), and (2) 1/4" nuts (H) from top handle
assembly.
7. Place top handle assembly between lower handles, align
mounting holes and install (2) 1/4 " x 1-1/4" carriage bolts
(F), (2) 1/4" lockwashers (G), and (2) 1/4" nuts (H). Carriage
bolts must be installed from the outside through square
holes in the lower handle, then through upper handle tube.
8. Securely tighten lower handle bolts first, then the upper
handle bolts.
Assure throttle cable is not twisted or wrapped around upper or lower handle.
9. Secure throttle linkage and stop switch lead midway on right upper and lower handle with cable clips.
A
B
C,D
B
C,D
E
F
G,H
G,H
F