Filter
Top Products
10
assembly
plastIc
shIeld InstallatIon
(Nylon line operation)
Parts Required: Plastic Debris Shield, Shield Plate,
three (3) 5 x 16 mm screws.
WARNING
The plastic shield is for use with the Nylon Line Head only. Install
Metal Shield when using plastic or metal blades, or serious injury
may result.
1. Align hole in upper plate (D) with notch in gear housing (G), and
insert locking tool to prevent splined shaft from turning. Arrow on
gear housing ange points to notch location.
2. Remove cotter pin (A), L.H. blade nut (B), lower plate (C), and
upper plate (D) from PTO shaft. Turn blade nut clockwise to
remove.
3. Remove locking tool. Retain lower plate, blade nut, and cotter
pin for future use with blade conversions.
4. Align plastic debris shield (F) with the drive shaft, and install on
the bottom of the gear housing ange.
5. Place shield plate (E) on shield, align holes and install three (3)
screws.
6. Replace upper plate (D) on PTO shaft.
E
D
F
C
B
A
D
G
nylon lIne head InstallatIon
Parts Required: Nylon Line Head.
CAUTION
Wear Gloves or personal injury may result:
• Cutoff knife is sharp.
• Gearcase and surrounding area may be hot.
1. Make sure plastic debris shield (F) is properly aligned, and upper
plate (D) is installed on splined PTO shaft.
2. Align hole in upper plate (D) with notch in gear housing (G), and
insert locking tool (H) to prevent splined shaft from turning.
3. Thread line head (I) onto PTO shaft by turning it counter-clock-
wise until head is tight against upper plate (D).
4. Remove locking tool.
H
D
G
F
I
D
H