Filter
Top Products
10
INSTALLATION OF NYLON LINE
HEAD(OPTION)
Set the nylon line head to the drive shaft and
tighten by turning as shown.
CUTTING PROCEDURES
Locking tool
OPERATING INSTRUCTIONS NYLON
LINE
1. Always use the end of the line for cutting.
Forcing the cutter head too close to the work
will result in reduced efficiency and broken line.
2. Maintain the line at the recommended length of
12.5 to 15 cm ( 5 to 6 in).
A longer line will reduce engine speed, a
shorter line may result in engine damage.
3. The trimmer head rotates counterclockwise.
Always cut with the head tilted to the right to
deflect debris away from the operator.
4. Always observe the SAFETY RULES on Page
3 when using the unit.
Upper fixing plate
TIGHTEN
Cutting head
1. REPLACING LINE
A. Remove spool by turning knob clockwise,
“right”, and separating parts.
B. Thread a 6 m (20 feet) length of 2.4 mm (0.095
in) or 2.7 mm (0.105 in) ECHO line through
hole in spool so that ends are the same length.
C. Wind both ends of line tightly and evenly
clockwise (see arrows on spool), and wind from
side to side without twisting the lines.
D. Secure ends of line temporarily with about 15
cm (6 in) extending out.
NOTE
Keep line tight on spool.
A. Snap spool into housing while pulling line
through eyelets with about 15 cm (6 in)
extending out.
CAUTION
Knob tightens counterclockwise, “left”.
B. Fasten spool to housing with shaft bolt, spring,
and knob.
2.REPLACING SPOOL
1C
1D
HOUSING
BOLT
SPRING
KNOB
1B
2A
15 cm (6 in)
SPOOL
2B