Filter
Top Products
Grass Trimmer/Brush CuTTer
25
OperaTOr's manual
nylon lIne replacement
1. Do not push spool in. Hold drum (A) and turn spool (B) clockwise
until peg clicks and disappears from hole. Pull spool out of drum.
2. Use one piece of new nylon line (C) 6 m (20 ft.) long and thread
through the molded loop (D) on the spool. Pull line tight and adjust
so one end is 15 cm (6 in.) longer than the other.
3. Hold the spool, opening toward you. Place index nger between
the two strands and wind line, tightly and evenly, in direction of
arrow (E).
4. Place ends of line (C) into notches (F) in spool, leaving 6 in. pro-
truding.
5. Feed ends of line outward through eyelets (G) in drum.
6. Align grooves in spool with pegs, and push spool (I), into drum.
7. Hold spool and drum securely with one hand, and pull each line to
disengage from notches.
8. Hold drum (A) and turn spool (B) counter clockwise until peg
clicks into hole.
9. Trim lines to 8 in. length.
D
I
C
G
G
FF
B
B
B
A
H
E
B
A