Echo SRM-266S Trimmer User Manual


 
Grass Trimmer/Brush CuTTer
19
OperatOr's Manual
aIr fIlTer
Level 1.
Parts required: REPOWER
TM
AIR & FUEL FILTER KIT.
1. Close choke (cold start position). This prevents dirt from entering
the carburetor throat when the air lter is removed. Brush accumu-
lated dirt from air cleaner area.
2. Remove air lter cover and air lter retainer from inside cover.
Brush dirt from inside cover.
3. Replace lter if it is damaged, very dirty, or the rubber sealing
edges are deformed.
4. Remove foam pre-lter and air lter and clean as indicated below:
Foam Pre-lter
Clean foam lter in water/detergent solution and rinse with clean
water.
Wrap the lter in a clean, dry cloth and squeeze (do not wring) dry.
Allow to dry completely before reuse. Do not oil.
Dual Layer Air Filter
Lightly brush debris from lter.
Soak heavily soiled lters in water/detergent solution to loosen dirt,
then brush lightly.
Rinse with clean water and allow to dry completely before reuse.
5. Place foam pre-lter over raised center and inside outer lip of air
lter. Install air lter in air lter case.
6. Install air lter retainer on post in air lter cover, at side up.
7. Install air lter cover and tighten cover knob securely.
fuel fIlTer
Level 1.
Parts required: REPOWER
TM
AIR & FUEL FILTER KIT.
DANGER
Fuel is VERY ammable. Use extreme care when mixing, storing
or handling, or serious personal injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and lter from the
tank.
3. Remove the lter from the line and install the new lter.
NOTE
Federal EPA regulations require all model year 2012 and later gasoline powered engines produced for sale in the
United States to be equipped with a special low permeation fuel supply hose between the carburetor and fuel tank.
When servicing model year 2012 and later equipment, only fuel supply hoses certied by EPA can be used to replace
the original equipment supply hose. Fines up to $37,500 may be enforced for using an un-certied replacement part.