Filter
Top Products
Gr a s s Tr i m m e r /Br u s h Cu T T e r
9
Op e r a T O r 's ma n u a l
co n t e n t s
The ECHO product you purchased has been partially assembled for your convenience. Due to packaging restrictions,
installation of the plastic debris shield, nylon line head, and positioning of the front handle are necessary.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
* Some units may be factory pre-assembled. No assembly tools are needed and the nylon line head, plastic debris shield,
and mounting hardware, shown in the contents list, are pre-assembled to the unit. Only the front handle may need to be
re-positioned for comfortable operation.
_______1 - Power Head / Drive Shaft Assembly
______ - 1, Operator's Manual
______ - 1, Safety Manual
______ - 1, Warranty Registration Card
_______ - 1, Safety Glasses
* _____ - 1, Nylon Trimmer Head
* _____ - 1, T-wrench
* _____ - 1, locking tool
* _____ --1, Plastic shield
* _____ --1, shield plate
* _____ --3, 5mm x 16mm screws (shield mtg.)
as s e m b l y
p l a s t I c
s h I e l d I n s t a l l a t I o n
(for Nylon Line Operation)
Tools Required: Screwdriver.
Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 16mm
screws.
NOTE
The plastic shield is for use with the Nylon Line Head only.
Install Metal Shield when using plastic or metal blades.
1. Remove plastic threaded shaft sleeve and adapter plate (C) from
PTO shaft (A).
2. Place the shield on the bottom of the bearing housing ange.
3. Place shield plate (B) on shield, align holes. Install three (3) screws
from bottom through plate and shield into gear case.
4. Assemble adapter plate (C) onto PTO shaft.
A
B
C