Filter
Top Products
13
SRM-2305
ASSEMBLING
Handle assembling bolt (8 mm)
Handle assembling
bracket (lower)
To engine
Washer
Install handle assembling bracket (upper) in handle
assembling bracket (lower) and fix handle by tightening
handle assembling bolt (8 mm) lightly.
Adjust inclination of handle to adequate position (easy to
operate) and tighten firmly handle assembling bolt (8 mm).
To eliminate loosening of throttle wire fix it to shaft tube
(2 places) and to right hand U-handle (1 place) with wire
fixing clips.
Handle assembling
bracket (upper)
Wire fixing clip
Shaft tube
Throttle wire
Nuts
CAUTION
After assembly, adjust the play of wire end on
carburettor side to 1 mm - 2 mm.
1 - 2 mm
Carburettor
Wire end
INSTALLATION OF BRACKET
Fit bracket to mounting portion of angle transmission and
fix the bracket by holding fitting plate pressed from beneath
and tightening 4 bolts (M5×25) lightly.
Get notches and convexes of fitting plate to face
corresponding convexes and concaves of bracket, and fix
bracket tightening 4 bolts (M5×25) securely.
Bracket
Bolt M5×25
Convex of fitting plate
Fitting plate
Notch of
fitting plate
There are two types of shields: namely one used exclusively
for Nylon line and another one used exclusively for steel
blade. When Nylon line is used, use the shield for Nylon
line. When steel blade is used, use the shield for steel
blade.
METHOD TO CHANGE SHIELD
(FOR STEEL BLADE)
Remove screw (M5×18) on the right side of the shield and
slide the shield to the left and remove it. Put shield of
another type into groove and slide it to the right until it stops
and be sure to fasten with the removed screw (M5×18).
When using Nylon line, use the shield for Nylon line
(see page 15). Fit cut off knife to the shield for Nylon line
using screw (5×12).
Bracket
Shield
Screw M5×18