Filter
Top Products
18
FRONT HANDLE INSTALLATION (SRM-211)
Tools Required: Screwdriver.
1. Position front handle for comfortable operation and secure screws.
U-HANDLE INSTALLATION
Tools Required: 8mm x 10mm Open End Wrench, Slotted Screwdriver,
(3mm Hex Wrench SRM-211 only.)
Parts Required: U-Handle Kit. (SRM-211) P/N 35130454130
NOTE
On model SRM-211U use Steps 9, 10, 12 - 15 only.
1. Disconnect ignition stop leads (E).
2. Remove inner throttle linkage from carburetor swivel (B).
3. Loosen nut (A) and remove throttle linkage from bracket.
4. Loosen two (2) bolts (G) and pull drive shaft assembly from clutch
case.
5. Loosen two (2) rear handle screws (H) and pull rear handle (I) from
the drive shaft assembly.
6. Loosen four (4) screws (J) and remove front handle.
I
G
J
H
A
B
E
E