Filter
Top Products
8
Tools Required: Screwdriver, Cross-Head Screwdriver
Parts Required: Power Pruner
TM
, Hedge Clipper Attachment
WARNING DANGER
Hedge Clipper cutting blades are very sharp! Always wear gloves
when handling assembly, otherwise serious personal injury may
result.
1. Loosen the four (4) screws (A) and locator screw (B) on Chain Saw
Cutting Attachment, then slide attachment off upper shaft tube (C).
NOTE
Do not remove locator screw (B) completely from cutting attach-
ment, otherwise inner lock nut will come off and be lost.
(Models: PPT Models Only)
2. Loosen center clamp knob (D).
ASSEMBLY
CUTTING
ATTACHMENT TO SHAFT TUBE INSTALLATION
SPECIFICATIONS
Approved for use with the following Power Pruner
TM
models only.
PPT-230/231 PPT-260/261
PPT-2100/2400 PPFD-2400
MODEL ----------------------------------------------------HEDGE CLIPPER ATTACHMENT
Length ------------------------------------------------------- 775 mm (30.5 in.)
Width--------------------------------------------------------121 mm (4.75 in.)
Weight ------------------------------------------------------ 2.45 kg (5.4 lbs.)
Gear Case Ratio -------------------------------------------- 3.5 : 1
Cutter -------------------------------------------------------- Double Reciprocating Blade - Double Edge
Cutter Length ----------------------------------------------- 450 mm (17.7 in.)
Cutter Pitch ------------------------------------------------- 28 mm (1.1 in.)
Maximum Diameter Cut ------------------------------------ 9.5 mm (3/8 in.)
C
D
C