Filter
Top Products
22
aIr fIlter
Level 1.
Parts required: REPOWER
TM
AIR & FUEL FILTER KIT.
1. Close choke (cold start position). This prevents dirt from entering
the carburetor throat when the air lter is removed. Brush accumu-
lated dirt from air cleaner area.
2. Remove air lter cover and air lter retainer from inside cover.
Brush dirt from inside cover.
3. Replace lter if it is damaged, very dirty, or the rubber sealing
edges are deformed.
4. Remove foam pre-lter and air lter and clean as indicated below:
Foam Pre-lter
• Clean foam lter in water/detergent solution and rinse with clean
water.
• Wrap the lter in a clean, dry cloth and squeeze (do not wring) dry.
Allow to dry completely before reuse. Do not oil.
Dual Layer Air Filter
• Lightly brush debris from lter.
• Soak heavily soiled lters in water/detergent solution to loosen dirt,
then brush lightly.
• Rinse with clean water and allow to dry completely before reuse.
5. Place foam pre-lter over raised center and inside outer lip of air
lter. Install air lter in air lter case.
6. Install air lter retainer on post in air lter cover, at side up.
7. Install air lter cover and tighten cover knob securely.
fuel fIlter
Level 1.
Parts required: REPOWER
TM
AIR & FUEL FILTER KIT.
DANGER
Fuel is VERY ammable. Use extreme care when mixing, storing
or handling, or serious personal injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and lter from the
tank.
3. Remove the lter from the line and install the new lter.